pipe bundle
英 [paɪp ˈbʌndl]
美 [paɪp ˈbʌndl]
网络 管束
双语例句
- Pipe bundle condenser is the equipment that in cylindrical shells are equipped with many parallel tubes composition bundle, through heat exchange to make solvent steam condensate.
列管冷凝器是在圆柱形壳体内装有很多平行管子组成管束，通过热交换使溶剂蒸汽冷凝的设备。 - The utility model provides a simple pipe binder used for pipe bundles in various mechanical structures, comprising a buckling sheet, a stud, a cylinder conductor, a jacket, and a pipe bundle ring.
本实用新型提供一种可在各种机械结构中用于管束的简易管束器。 - Ultrasonic casing inspection tool Principle and Application of Circumgyrate-ultrasonic Measure for Pipeline and Heat Exchanger Pipe Bundle
旋转超声检测仪在管道与换热器管束检测中的应用研究 - Causes and Countermeasures of Leakage for Convection Pipe Bundle of Waste Heat Boiler in the Catalytic Unit
催化余热锅炉对流管束胀口泄漏的原因及处理 - Research on natural frequency of U pipe bundle of heat exchanger
U型管换热器管束固有频率研究 - An approach of rough-fuzzy control, which uses rough set data analysis to upgrade fuzzy PID control, is presented for the electro-hydraulic servo position system in pipe bundle shaping process.
针对浙江大学研制的智能管捆成形电液位置伺服系统，应用粗糙集数据分析的理论，提出一种有自学习能力的粗糙-模糊PID控制方法。 - Based on the balance of energy, the mathematic model of soil cool thermal storage and release process of inner and outer pipe in the buried pipe bundle was established.
并在能量平衡的基础上，建立了埋管管束内层及外层盘管蓄冷、释冷过程的数学模型。 - The arranged pipe heater of vertical cylindrical storage oil tank often occurred damage at the joint zone between the distributor pipe and bundle.
立式圆筒形储罐用的排管式加热器，在分配管与管束连接处经常发生损坏。 - The main research work is shown below: In the first chapter, owing to the necessity of products packing and the development of steel pipe packing system, worldwide investigating development of steel pipe bundle intelligent stacking and strapping system was introduced.
第一章从钢管产品包装的重要性和钢管包装系统研制的必要性出发，介绍了国内外钢管捆智能成形打捆包装系统的现状，阐述了该系统所涉及的关键技术和研究状况及其发展趋势。 - Pipe Bundle Cleaning by High Pressure Water Jet
管束的高压水射流清洗 - Experimental results show that the combined distributor, which is arranged in the inlet of chamber of the multi-pipe liquid-solid circulating fluidized bed, can effectively improve the uniformity of solid particle in the pipe bundle.
试验结果表明，在多管循环液固流化床下管箱安装组合式分布器可以实现固体颗粒在管束中的均匀分配。 - The generating and flowing of the stream induces pipe bundle vibration that becomes especially stronger under the action of gas-fluid two phase flow, which produces cyclic load on the welded joint of tube-plate and brings fatigue broken.
壳程内蒸气的发生和流动诱发振动，使管束发生振动，特别在汽液两相流作用下使振动加剧，使管板焊接接头部位产生循环载荷造成疲劳破坏。 - The experimental results are collected and compared on single experimental pipe, cross tube bundle, rectangle and triangle cross fin-tube.
对单根试验管、叉排管束、矩形截面超片管和三角形截面翅片管的试验结果进行了综合比较。 - Bubble distribution characters along the circumference of single pipe and pipe bundle dipped into the fluidized bed and their influence on local coefficient of heat transfer
流化床内浸入单管及管束沿周向气泡的分布特性及其对局部换热系数的影响 - Under the condition of gravity control, experimental study are carried out of heat transfer in condensers with different internal supporting structures and pipe bundle combinations, and characteristic curves of condensation heat transfer are obtained for water vapor in the shell side of condensers.
在重力控制条件下，对不同内部支承结构与管束组合的冷凝器进行了传热实验研究，得到了水蒸气在冷凝器壳侧的冷凝传热特性曲线。 - Corrosion of heat exchanger pipe bundle of 316L stainless steel for distillation tower overhead
常压塔顶316L不锈钢换热器管束的腐蚀失效分析 - Hoisting of Pipe Bundle of Extraneous Heat Remover at Catalytic Equipment Using Pulley Block
巧设滑车组吊装催化装置外取热器管束 - High pressure water jet was used to clean pipe bundle, achieving safety and highly effective efficiency.
应用高压水射流进行管束清洗，具有安全高效等特点。 - The paper analyzes the tail rope failure and fault reasons, the design thoughts using double spinner, steel rope core rubber belt, rubber bushed steel rope and pipe bundle steel rope are put forward.
分析了尾绳失效和引起故障的原因，提出了双旋转器、钢丝芯胶带、套胶钢丝绳和管束钢丝绳等设计思想。 - By means of macro inspection, X ray diffraction, scanning electron microscope, optical microscopy and EDS, corrosion of heat exchanger pipe bundle of 316L stainless steel for a distillation tower overhead was analyzed.
通过宏观、金相观察、X射线衍射及SEM等方法分析了炼油厂常压塔顶316L不锈钢换热器管束的腐蚀形态及原因。 - Distribution of solid particle in the pipe bundle was analysed in a cold model system and solid holdup and particle circulation rate were investigated.
利用建立的小型冷态试验装置，考察了管束中的颗粒循环速率和固含率。